Enquiry 0Discuss your project
Menu

Application overview

Waterproofing chemicals in Pakistan.

Select the material for the construction detail.

Explore waterproofing coatings, crystalline products, local leak-plugging materials and joint-detail components. Compare their roles, review the matching documents, and discuss your project with SEED Chemicals.

Review the substrate, water path and access before choosing a product role. Coatings, admixtures, local plugging and joint details serve different parts of the work.

Illustrative basement and waterproofing construction context.
Illustrative application context. Assess the actual water path, substrate and construction detail.

Choose the waterproofing role before choosing the product

Start with the structure, not the product name. Is the work new concrete or an existing surface? Is the substrate concrete, masonry or another mineral material? Where is water entering, and which face can you reach?

SEED Chemicals brings together TENSYL, IZONIL and VELOSIT product references for different parts of the work. Use the choices below to narrow your enquiry, then review the exact product and its matching documents. Products shown together are not automatically interchangeable or compatible.

Different parts of the work

Compare the exact material roles.

Open each approved reference for its scope, illustrations, qualifications and matching document route.

Explore the TENSYL, VELOSIT and IZONIL ranges, then confirm the exact selected product and its matching documents.

Existing concrete: crystalline treatment

VELOSIT CW 111 is a surface-applied crystalline waterproofing product for concrete. Its role differs from an admixture added during concrete mixing. It is not a treatment for plaster, masonry or decorative putty. Existing active leaks, leaking cracks, joints and penetrations require their separate specified details.

Prepared mineral surfaces: coating options

TENSYL CC101 is a two-part cementitious waterproofing coating for prepared mineral surfaces, with wet areas and below-tile work among its stated uses.

VELOSIT WP 100 is a rigid cementitious coating for suitable concrete and masonry. VELOSIT WP 124 is a polymer-modified coating with flexible and semi-flexible formulation options. These descriptions do not select a complete system: the substrate, water direction, movement, components and intended finish still need to be matched to the project.

New concrete: an admixture route

VELOSIT CA 112 is a powder admixture added to fresh concrete, rather than a coating applied afterwards. Selection belongs with the concrete mix design and trials. Placement, compaction, curing and joint waterproofing remain separate requirements; an admixture does not remove them.

Local leaks and junctions: separate material roles

VELOSIT PC 221 has a local leak-plugging and rapid small-repair role. VELOSIT DB 830 is an embedded surface joint tape. Neither should be treated as a substitute for assessing the surrounding waterproofing detail. Identify cracks, corners, drains and pipe entries when describing the work.

Bring the site condition into the selection

For roof leakage, begin with the roof diagnosis guide. For below-ground work, compare positive- and negative-side access. For bathrooms, review the junctions that matter before tiling.

If the structure holds drinking water, use the potable-water document checklist. A general waterproofing description does not establish approval for drinking-water contact.

Check the documents, then prepare your enquiry

The technical documents hub separates product overviews, available manufacturer references and requests for current technical or safety sheets. Confirm that the documents match the exact supplied product and components. A catalogue reference does not confirm local stock or suitability for your project.

For a useful first discussion, share:

You do not need every answer to start. Prepare a project enquiry or ask for technical support.

Bring the detail into the enquiry.

Share photographs, substrate, exposure, construction stage, access and the intended finish. Confirm the exact selected product and matching technical and safety sheets before specification or work.

Prepare a waterproofing enquiry