VELOSIT WP 100

Cementitious waterproofing slurry

Rigid cementitious waterproofing slurry for specified mineral substrates.

mixing recipe hold

Archived source issuer: VELOSIT GmbH & Co. KG. Printed edition: 3219. This SEED-prepared summary is not an OEM reissue.

Product code: WP 100
Packaging: 20 kg watertight plastic bag
Coverage / consumption: Brush application: 3.4 kg/m² total for 2 mm dry film across two coats

View inquiry Technical documents

VELOSIT WP 100 — Manufacturer application image — Manufacturer-source application photograph from the archived VELOSIT WP 100 technical sheet. Shown as application context; confirm current mixing instructions.

Material overview

Rigid cementitious waterproofing slurry for specified mineral substrates. Technical details are attributed to the archived VELOSIT source 3219. Confirm the current matching manufacturer documentation and project suitability before use.

Applications

Waterproofing concrete and masonry basements and below-grade structures
Specified elevator pits and rising-damp treatment
Preparatory rigid waterproofing beneath specified flexible systems

Reviewed technical data

Recorded source values with stated conditions. This review does not establish a current product release or approval.

Packaging: 20 kg watertight plastic bagvelosit wp 100 tds; 3219 pp. 3
Consumption: Approximately 1.7 kg powder/m² per mm dry-film thicknessvelosit wp 100 tds; 3219 pp. 3
Coverage example: Brush application: 3.4 kg/m² total for 2 mm dry film across two coatsvelosit wp 100 tds; 3219 pp. 3
Substrate temperature: 5–35 °Cvelosit wp 100 tds; 3219 pp. 3
Compressive strength in source tests: 15 MPa at 24 hours; 30 MPa at 28 daysvelosit wp 100 tds; 3219 pp. 3
Storage: The archived sheet states 12 months in unopened original packaging at 5–35 °C, dry and protected from sunlight. Confirm the supplied batch and current manufacturer requirements.

Application & safety

Method of application

Prepare a sound, pore-open mineral substrate and remove bond-breaking material. Stop active leaks, repair defects and pre-dampen to saturated surface dry. The source gives minimum adhesive/compressive substrate strengths of 1.5/25 MPa, with conditional exceptions requiring specification review. Request a corrected current mixing instruction before use. After confirmation, follow the selected brush, trowel or spray procedure. The source’s brush example is two coats giving 2 mm total dry-film thickness, with approximately three hours between coats at 23 °C. Hot or very dry conditions require the stated 24-hour water curing.

Safety notes

Consult the current product safety data sheet and follow its handling measures before use. The archived technical sheet is not a substitute for an SDS.

For project selection and substrate-specific advice, contact technical support.

Review limits

Do not provide mixing quantities from the inconsistent source.
Do not imply positive- and negative-side pressure ratings are equal.

Mixing percentages, litres and table ratio conflict. Obtain corrected manufacturer instructions before mixing.
Pressure units are inconsistent; numerical pressure ratings and current potable-water approval remain unverified.

Confirm the exact supplied product, substrate, exposure and current TDS/SDS with technical support.